一本加勒比HEZYO高清


Contact Heju Collection and gathering Online Message Website map Welcome to Dongguan Heju Precision Electronic Technology Co., Ltd

National Service Hotline: 135-2852-2558

 Metal stamping parts, stamping processing, stamping plant, precision stamping

30 years of experience in electronic hardware shrapnel customization Specializing in high difficulty, high precision, special-shaped non-standard shrapnel processing plant

What kinds of stamping dies are there for precision stamping parts

 Back to list Source: Heju hardware Browse: - Release date: October 8, 2020【 large in Small
Dongguan Heju Precision Electronic Technology Co., Ltd. is a professional precision hardware design, production and production manufacturers. The main production and processing of precision hardware shrapnel, precision terminals Precision stamping parts Etc. Our factory constantly learn advanced production technology and introduce advanced production equipment to ensure the production of high-quality products and provide high-quality services for customers.
 
Precision stamping parts Molds can be classified into three categories as follows:
 
Engineering die: also known as "single process Die", it refers to the die which can only complete one stamping process in one stroke of stamping. After the completion of the project, the products need to be taken out of the mold manually or by a manipulator, and then put into the mold of the next station to continue production, until the last process of the mold is finished, the whole product is considered to be completed. Mold maintenance is simple, but the production is time-consuming and laborious, which requires more labor and time cost, and the product scrap rate is high.
 
Compound die: common compound die structure includes compound blanking, compound drawing, etc., which is slightly different from other engineering die structures. The punch (also known as male die or punch) is designed in the lower die. The other templates are the lower clamping plate (fixed punch), the lower stop plate and the lower stripper plate (outer stripping). The upper die is composed of the female die (or knife edge), the inner stripper and the upper backing plate. The inner stripper is hung on the upper base plate with an equal height sleeve, and then jacked with a striking rod or spring.
 
Continuous die: also known as "progressive die", it refers to the mold that completes two or more stamping processes at different positions in one stroke of stamping. This kind of mold is difficult to maintain and needs experienced fitter to operate, but it has high production efficiency, can save labor and time cost, and has low scrap rate of precision metal stamping parts.
 Precision stamping parts
This article is from the official website of Heju http://www.hejujingmi.com/

Recommended reading